These systems comprise mainly of the LS Series length cutting saws, type DAa 79/80 Double end profilers with transfer units and type F 100 cross cut saws.
- Length-edge-processing with Length cutting saw (type LS) or Double end Tenoner (type DAa)
- Cross-processing with a Cross cut saw (type F 100) with saw motors positioned below
Length cutting saw type LS
- for trimming and length-dividing of sheet materials like raw and coated chipboards, MDF–panels, blockboards et al. in continuous flow.
- processing of single panels from below or, if required, from above
- transport- and pressure-rollers before and after trimming- and dividing saws for guide and transport of the panel material
Cross processing Saw system F 100
- cross processing of the panels with processing motors positioned below
- transport of the panel (at the trimmed edge), with a pushing beam from the length-processing-unit through the cross-trimming-saws
- transport of the panel after the cross-trimming with a pushing beam on a lifting device or transport unit arranged beside of the depositing table
